Before I open my mouth… just how much work am I looking at and where can I rent equipment???…
This is what I found on the internet…. didn’t look impossible.
Refinish a deck:
1. Use a hammer to refasten protruding nails.
2. Trim raised edges with a sandpaper block, electric sander, or plane.
3. As needed, clean gray or dirty wood with a solution of 1 cup bleach in a gallon of water. Apply with a brush or broom.
4. Use a pressure washer to clean the deck, being careful not to damage the wood with excessive pressure.
5. Apply stain or wood preservative following the manufacturer’s instructions.
6. Apply wood sealer following manufacturer’s instructions.
12 Volt Sump Pump
Is it possible to bend the wood across its width? If so, how? Or do I need to simply lay the boards parallel to the deck and then trim the ends?
Alcoa Vinyl Siding